BIR005 stainless steel bird post 150mm

Stainless steel threaded rods as part of the bird deterrent wire system to tension wires at the correct height.
Lengths depending on the application, optionally with an anchor plug or a plastic base.

Use a 150mm threaded rod in combination with the 25mm anchor plug to install the first wire on the edge at approximately 130mm height.

Assemble the materials list yourself using the explanation below or download the instructions.

Bird Deterrent System Explanation:
The bird deterrent wire system is a flexible system that can lead to excellent results when properly applied to prevent pigeons on, among other things, edges and ledges. The materials are primarily made of stainless steel.
 
The thin nylon coated stainless steel wire must be tensioned between threaded rods using wire clips. The threaded rods must be placed at a maximum distance of 150cm. The wire is tensioned with a micro spring at every second rod, so tension a maximum of 3 meters per spring. The rods can be attached by drilling (using a 25mm anchor plug) or by screwing/gluing (using a plastic base). Where one ends at a vertical wall, an anchor plug (25mm) with a cotter pin (25mm) can be mounted in the vertical wall to finish off the wire.

Threaded rods are used to keep the stainless steel bird deterrent wire at the correct height above the edge or ledge.
For effective pigeon deterrence, it is recommended to apply at least two rows. The front row, at about 20mm distance from the edge, should have a wire height of about 100mm. The second and subsequent rows should have a wire height of about 130mm. Due to the two height differences and the two different mounting methods (drilling with the anchor plug, or mounting with the plastic base), the threaded rods are available in 4 different lengths.

Stainless steel bird deterrent wire must be secured through loops.
Wire clips are used to create loops.
With the special crimping tool, the wire clips can be fixed onto the wire.