BIR018 birdwire crimp and cutter tool

Crimping tool to squeeze the wire clamps onto the wire, belonging to the bird deterrent wire system.

Compile the material list yourself using the explanation below or download the instructions.

Bird deterrent system explanation:
The bird deterrent wire system is a flexible system that can yield excellent results when properly applied for repelling pigeons on edges and ledges. The materials are mainly made of stainless steel.
 
The thin nylon-coated stainless steel wire should be tensioned between wire rods using wire clamps. The wire rods should be placed at a maximum distance of 150cm. The wire is tensioned with a micro spring at every second rod, so a maximum of 3 meters per spring. The rods can be attached through drilling (use anchor plug 25mm) or screwing/gluing (use plastic base). Wherever you end at a vertical wall, an anchor plug (25mm) with a split pin (25mm) can be mounted in the vertical wall to finish off the wire.

Wire rods are used to keep the stainless steel bird deterrent wire at the correct height above the edge or ledge.
For effective pigeon deterrence, it is recommended to apply at least two rows. The front row, at about 20mm from the edge, should have a wire height of about 100mm. The second and subsequent rows should have a wire height of about 130mm. Due to the two height differences and the two different mounting methods (drilling with anchor plug, or mounting with plastic base) the wire rods are available in 4 different lengths.

Stainless steel bird deterrent wire should be secured with loops.
Wire clamps are used to make loops.
With the special crimping tool, the wire clamps can be fixed onto the wire.